Page Comparison

...

1. During boot press & hold the middle switch until the status pixel turns solid blue

2. Release the middle switch, and the current MIDI channel will flash on the Footswitch 1 oixel:

   1. A red flash means +5

   2. A green flash means +1

      1. Example - Channel 1 = 1 green flash

      2. Example - Channel 7 = 1 red flash + 2 green flashes

      3. Example - Channel 14 - 3 red flashes + 4 green flashes

3. The Left switch decrements the channel by 1, while the Middle switch increments by 1

4. Wait 10 seconds and it’ll automatically save

Snapshot Mode:Hold

#2 for snapshot mode. till status pixel goes solid, release, then #2 changes; flood white == enable, flood red == disabledSnapshot mode puts the 3 switches into a mode where the 3 switches & their LED’s represent the 3 snapshots available on the HXStomp. Please note that when switching presets, the HX does not provide a way to “follow” the snapshot so after changing to a bank, press a footswitch to sync back up what snapshot is active.

To get into Snapshot mode:

1. During boot press and hold the right switch until the status pixel turns solid green, then release

2. The far right switch turns snapshot mode on and off.

   1. All-white == snapshot mode

   2. All-red == not snapshot mode; i.e do the regular programmed footswitch commands from above

3. While in Snapshot mode (These are currently not changable):

   1. Hold Left Switch for FS4

   2. Hold Middle Switch for FS5

   3. Hold Right Switch for Tuner